Alcatel-Lucent 7210 SAS M Service Manual page 603

single-sfm-overload
Syntax single-sfm-overload [holdoff-time holdoff-time]
no single-sfm-overload
Context config>service>vprn
This command, if enabled, will cause the IGP protocols (either IS-IS or OSPF) for the service to enter
Description
an overload state when the node only has a single SFM functioning.
The no form of this command causes the overload state to be cleared.
no single-sfm-overload
Default
holdoff-time — This parameter specifies the delay between the detection of a single SFM and
Parameters
snmp-community
Syntax snmp-community community-name [version SNMP-version]
no snmp-community [community-name]
Context config>service>vprn
This command sets the SNMP community name to be used with the associated VPRN instance.
Description
If an SNMP community name is not specified, then SNMP access is not allowed.
The no form of the command removes the SNMP community name from the given VPRN context.
None — The SNMP community must be explicitly specified.
Default
community-name — Specifies one or more SNMP community names.
Parameters
version SNMP-version — Specifies the SNMP version.
source-address
Syntax source-address
Context config>service>vprn
This command enables the context to specify the source address and application that should be used
Description
in all unsolicited packets.
7210 SAS M Services Guide
enacting the overload state.
1—600 seconds
Values
0 seconds
Default
Values v1, v2c, both
Virtual Private Routed Network Services
Page 603