Alcatel-Lucent 7210 SAS M Service Manual page 659

the load on peers without affecting the route convergence time for stable routes. Damping parameters
are set via route policy definition.
The no form of the command used at the global level disables route damping.
The no form of the command used at the group level reverts to the value defined at the global level.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
When damping is enabled and the route policy does not specify a damping profile, the default
damping profile is used. This profile is always present and consists of the following parameters:
Half-life:
Max-suppress:
Suppress-threshold:3000
Reuse-threshold 750
no damping — Learned route damping is disabled.
Default
disable-4byte-asn
Syntax [no] disable-4byte-asn
Context config>service>vprn>bgp
config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
This command disables the use of 4-byte ASNs. It can be configured at all 3 level of the hierarchy so
Description
it can be specified down to the per peer basis.
If this command is enabled 4-byte ASN support should not be negotiated with the associated remote
peer(s).
The no form of the command resets the behavior to the default which is to enable the use of 4-byte
ASN.
disable-capability-negotiation
Syntax [no] disable-capability-negotiation
Context config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
This command disables the exchange of capbilities. When command is enabled and after the peering
Description
is flapped, any new capabilities are not negotiated and will strictly support IPv4 routing exchanges
with that peer.
The no form of the command removes this command from the configuration and restores the normal
behavior.
no disable-capability-negotiation
Default
7210 SAS M Services Guide
15 minutes
60 minutes
Virtual Private Routed Network Services
Page 659