Alcatel-Lucent 7210 SAS M Service Manual page 116

ETH-CFM Configuration Commands
name ma-name — Specifies the part of the maintenance association identifier which is unique within
bridge-identifier
Syntax [no] bridge-identifier bridge-id
Context config>eth-cfm>domain>association
This command configures the service ID for the domain association. The value must be configured to
Description
match the service-id of the service where MEPs for this association will be created. Note that there is
no verification that the service with a matching service-id exists. This is not used for facility MEPs as
they are not tied to services.
bridge-id — Specifies the bridge ID for the domain association.
Parameters
mhf-creation
Syntax mhf-creation {none | explicit}
no mhf-creation
Context config>eth-cfm>domain>association>bridge-identifier
This command determines whether to allow automatic MIP creation for the MA.
Description
none
Default
none — Specifies that no MHFs can be created for this VID.
Parameters
explicit — Specifies that MHFs can be created for this VID only on bridge ports through which this
vlan
Syntax vlan vlan-id
no vlan
Context config>eth-cfmg>domain>association>bridge-identifier
This command configures the bridge-identifier primary VLAN ID. Note that it is informational only,
Description
and no verification is done to ensure MEPs on this association are on the configured VLAN.
vlan-id — Specifies a VLAN ID monitored by MA.
Parameters
Page 116
the maintenance domain name.
1 — 45 characters
Values
1 — 2147483647
Values
VID can pass, and only if a MEP is created at some lower MA level. There must be at least one
lower level MEP provisioned on the same SAP.
0 — 4094
Values
7210 SAS M Services Guide