Configuring A Vpls Sap - Alcatel-Lucent 7210 SAS M Service Manual

Configuring a VPLS Service with CLI

Configuring a VPLS SAP

A default QoS policy is applied to each ingress SAP. Additional QoS policies can be configured in
the config>qos context. There are no default filter policies. Filter policies are configured in the
config>filter context and must be explicitly applied to a SAP.
Use the following CLI syntax to create:
VPLS SAP
•
•
Local VPLS SAPs
To configure a local VPLS service, enter the sap sap-id command twice with different port IDs in
the same service configuration.
*A:ALA-1>config>service# info
----------------------------------------------
----------------------------------------------
*A:ALA-1>config>service#
Page 318
Local VPLS SAPs on page 318
Distributed VPLS SAPs on page 319
vpls 1150 customer 1 create
fdb-table-size 1000
fdb-table-low-wmark 5
fdb-table-high-wmark 80
local-age 60
stp
shutdown
exit
sap 1/1/1:1155 create
exit
sap 1/1/2:1150 create
exit
no shutdown
exit
7210 SAS M Services Guide