Alcatel-Lucent 7210 SAS M Service Manual page 680

Hide thumbs Also See for 7210 SAS M:
Table of Contents

Advertisement

Show, Clear, Debug Commands
Opr
Oper State
Flags
Signal
Signaling
Last Status Change
Adv. NTU Over
Last Mgmt Change
KeepAlive Infor-
mation
Hello Time
Hello Msg Len
Hello Timeout
Unmatched Replies
Max Drop Count
Hold Down Time
TX Hello Msgs
Rx Hello Msgs
Associated LSP
List
Lsp Name
Time Since Last
Transaction
Signaling
Page 680
Label
The operating state of the SDP.
Specifies all the conditions that affect the operating status of this SDP.
The signaling protocol used to obtain the ingress and egress labels used in
frames transmitted and received on the SDP.
The time of the most recent operating status change to this SDP.
Specifies whether the advertised MTU of a VLL spoke SDP bind includes
the 14-byte L2 header, so that it is backward compatible with pre-2.0 soft-
ware.
The time of the most recent management-initiated change to this SDP.
This section displays Keepalive information.
Specifies how often the SDP echo request messages are transmitted on this
SDP.
The length of the SDP echo request messages transmitted on this SDP.
The number of seconds to wait for an SDP echo response message before
declaring a timeout.
The number of SDP unmatched message replies timer expired.
The maximum number of consecutive SDP echo request messages that can
be unacknowledged before the keepalive protocol reports a fault.
The amount of time to wait before the keepalive operating status is eligible
to enter the alive state.
The number of SDP echo request messages transmitted since the keepalive
was administratively enabled or the counter was cleared.
The number of SDP echo request messages received since the keepalive was
administratively enabled or the counter was cleared.
When the SDP type is MPLS, a list of LSPs used to reach the far-end router
displays. All the LSPs in the list must terminate at the IP address specified in
the far end field.
Displays the LSP name.
Displays the time of the last transaction.
Specifies the signaling type.
Description (Continued)
7210 SAS M Services Guide

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents