Alcatel-Lucent 7210 SAS M Service Manual page 403

mode
Syntax mode {rstp | comp-dot1w | dot1w | mstp | pmstp}
no mode
Context config>service>vpls>stp
This command specifies the version of Spanning Tree Protocol the bridge is currently running.
Description
See section
The no form of this command returns the STP variant to the default.
rstp
Default
rstp — Corresponds to the Rapid Spanning Tree Protocol specified in IEEE 802.1D/D4-2003.
Parameters
dot1w — Corresponds to the mode where the Rapid Spanning Tree is backward compatible with
compdot1w — Corresponds to the Rapid Spanning Tree Protocol fully conformant to IEEE 802.1w.
mstp — Sets MSTP as the STP mode of operation. Corresponds to the Multiple Spanning Tree
pmstp — The PMSTP mode is only supported in VPLS services where the mVPLS flag is
mst-instance
Syntax [no] mst-instance mst-inst-number
Context config>service>vpls>stp
This command creates the context to configure Multiple Spanning Tree Instance (MSTI) related
Description
parameters. MSTP supports "16" instances. The instance "0" is mandatory (by protocol) and cannot
be created by the CLI. The software automatically maintains this instance.
none
Default
mst-inst-number — Specifies the Multiple Spanning Tree instance.
Parameters
mst-priority
Syntax mst-priority bridge-priority
no mst-priority
Context config>service>vpls>stp>mst-instance
This command specifies the bridge priority for this specific Multiple Spanning Tree Instance for this
Description
service. The bridge-priority value reflects likelihood that the switch will be chosen as the regional
7210 SAS M Services Guide
Spanning Tree Operating Modes on page 263
IEEE 802.1w.
Protocol specified in 802.1Q REV/D5.0-09/2005
configured.
1 — 4094
Values
Virtual Private LAN Services
for details on these modes.
Page 403