Alcatel-Lucent 7210 SAS M Service Manual page 725

Sample Output
*A:ALA-12# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId
------------------------------------------------------------------------------
10
40
60
100
500
------------------------------------------------------------------------------
Number of SDPs : 5
==============================================================================
*A:ALA-12#
*A:ALA-12# show service sdp 2 detail
===============================================================================
Service Destination Point (Sdp Id : 2) Details
===============================================================================
-------------------------------------------------------------------------------
-------------------------------------------------------------------------------
Description
SDP Id
Admin Path MTU
Far End
Admin State
Flags
Signaling
Last Status Change
Last Mgmt Change
KeepAlive Information :
Admin State
Hello Time
Hello Timeout
Max Drop Count
Tx Hello Msgs
Associated LSP LIST :
7210-SAS M Services Guide
Label
TX Hello Msgs
Rx Hello Msgs
Associated LSP
List
Adm MTU Opr MTU
4462 4462
4462 1534
4462 1514
4462 4462
4462 4462
Sdp Id 2 -(10.10.10.104)
: GRE-10.10.10.104
: 2
: 0
: 10.10.10.104
: Up
: SignalingSessDown TransportTunnDown
: TLDP
: 02/01/2007 09:11:39
: 02/01/2007 09:11:46
: Disabled
: 10
: 5
: 3
: 0
Description (Continued)
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared.
Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
If the SDP type is GRE, then the following message displays:
SDP delivery mechanism is not MPLS
IP address
10.20.1.3
10.20.1.20
10.20.1.21
180.0.0.2
10.20.1.50
Oper Path MTU
Delivery
Oper State
VLAN VC Etype
Adv. MTU Over.
Oper State
Hello Msg Len
Unmatched Replies
Hold Down Time
Rx Hello Msgs
VPRN Show Commands
Adm Opr Deliver Signal
Up Dn NotReady MPLS
Up Up MPLS
Up Up GRE
Down Down GRE
Up Dn NotReady GRE
: 0
: GRE
: Down
: 0x8100
: No
: Disabled
: 0
: 0
: 10
: 0
TLDP
TLDP
TLDP
TLDP
TLDP
Page 725