Alcatel-Lucent 7210 SAS M Service Manual page 105

metric
Syntax metric metric
no metric
Context config>service>sdp
This command specifies the metric to be used within the tunnel table manager for decision making
Description
purposes. When multiple SDPs going to the same destination exist, this value is used as a tie-breaker
by tunnel table manager users such as MP-BGP to select the route with the lower value.
metric — Specifies the SDP metric.
Parameters
ldp
Syntax [no] ldp
Context config>service>sdp
This command enables LDP-signaled LSP's on MPLS-encapsulated SDPs.
Description
In MPLS SDP configurations either one LSP can be specified or LDP can be enabled. The SDP ldp
and lsp commands are mutually exclusive. If an LSP is specified on an MPLS SDP, then LDP cannot
be enabled on the SDP. To enable LDP on the SDP when an LSP is already specified, the LSP must be
removed from the configuration using the no lsp lsp-name command.
Alternatively, if LDP is already enabled on an MPLS SDP, then an LSP cannot be specified on the
SDP. To specify an LSP on the SDP, the LDP must be disabled. The LSP must have already been
created in the config>router>mpls context with a valid far-end IP address. The above rules are
relaxed when the mixed-lsp option is enabled on the SDP.
no ldp (disabled)
Default
lsp
Syntax lsp lsp-name
no lsp lsp-name
Context config>service>sdp
This command creates associations between one label switched paths (LSPs) and an Multi-Protocol
Description
Label Switching (MPLS) Service Distribution Point (SDP). This command is implemented only on
MPLS-type encapsulated SDPs.
In MPLS SDP configurations either one LSP can be specified.
The LSP must have already been created in the config>router>mpls context. with a valid far-end IP
address. RSVP must be enabled.
If no LSP is associated with an MPLS SDP, the SDP cannot enter the operationally up state. The SDP
can be administratively enabled (no shutdown) with no LSP associations. The lsp-name may be
7210 SAS M Services Guide
0 — 65535
Values
Subscriber Services
Page 105