Alcatel-Lucent 7210 SAS M Service Manual page 529

IES Interface IPv6 Commands
ipv6
Syntax [no] ipv6
Context config>service>ies>if
This command enables the context to configure IPv6 for an IES interface.
Description
address
Syntax address ipv6-address/prefix-length [eui-64]
no address ipv6-address/prefix-length
Context config>service>ies>if>ipv6
This command assigns an IPv6 address to the IES interface.
Description
ipv6-address/prefix-length — Specify the IPv6 address on the interface.
Parameters
eui-64 — When the eui-64 keyword is specified, a complete IPv6 address from the supplied prefix
icmp6
Syntax icmp6
Context config>service>ies>if>ipv6
This command configures ICMPv6 parameters for the IES interface.
Description
packet-too-big
Syntax packet-too-big [number seconds]
no packet-too-big
Context config>service>ies>if>ipv6>icmp6
7210-SAS M Services Guide
ipv6-address/prefix: ipv6-address
Values
prefix-length
and 64-bit interface identifier is formed. The 64-bit interface identifier is derived from MAC
address on Ethernet interfaces. For interfaces without a MAC address, for example ATM
interfaces, the Base MAC address of the chassis is used.
IES Service Configuration Commands
x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x [0 — FFFF]H
d [0 — 255]D
1 — 128
Page 529