Alcatel-Lucent 7210 SAS M Service Manual page 735

7210-SAS M Services Guide
Label
Acct. Pol
Collect Stats
Spoke SDPs
Managed by Service
Managed by Spoke
Prune state
Peer Pw Bits
Max IPv4 Routes
Last Changed
Dot1Q Ethertype
Ingr IP Fltr-Id
Ingr Mac Fltr-Id
Egr IP Fltr-Id
Egr Mac Fltr-Id
tod-suite
rate
burst
Classifiers Allo-
cated
Classifiers Used
Meters Allocated
Indicates the accounting policy applied to the SAP.
Specifies whether accounting statistics are collected on the SAP.
Specifies the service-id of the management VPLS managing this spoke
SDP.
Specifies the sap-id inside the management VPLS managing this spoke
SDP.
Specifies the STP state inherited from the management VPLS.
Indicates the bits set by the LDP peer when there is a fault on its side of
the pseudowire. LAC failures occur on the SAP that has been config-
ured on the pipe service, PSN bits are set by SDP-binding failures on
the pipe service. The pwNotForwarding bit is set when none of the
above failures apply, such as an MTU mismatch failure. This value is
only applicable if the peer is using the pseudowire status signalling
method to indicate faults.
pwNotForwarding — Pseudowire not forwarding
lacIngressFault Local — Attachment circuit RX fault
lacEgresssFault Local — Attachment circuit TX fault
psnIngressFault Local — PSN-facing PW RX fault
psnEgressFault Local — PSN-facing PW TX fault
pwFwdingStandby — Pseudowire in standby mode
Maximum IPv4 routes configured for use with the service.
The date and time of the most recent management-initiated change.
The Dot1q ethertype in use by the SAP.
The policy ID of the IP filter applied at ingress.
The policy ID of the MAC filter applied at ingress.
The policy ID of the IP filter applied at egress.
The policy ID of the MAC filter applied at egress.
The TOD suite applied for use by this SAP.
Specifies the SAP aggregate rate configured for the aggregate policer/
meter used by this SAP.
Specifies the burst to be used with SAP aggregate policer/meter used
by this SAP.
Number of SAP ingress QoS resources allocated for use by this SAP.
Number of SAP ingress QoS resources in use by this SAP.
Number of SAP ingress meter resources allocated for use by this SAP.
This is set to half the number of classifiers allocated to this SAP.
VPRN Show Commands
Description
Page 735