Alcatel-Lucent 7210 SAS M Service Manual page 790

Show, Clear, Debug Commands
==============================================================================
tunnel-table
Syntax tunnel-table [ip-address[/mask] [protocol protocol | sdp sdp-id]
tunnel-table [summary]
Context show>router
This command displays tunnel table information.
Description
When the auto-bind command is used when configuring a VPRN service, it means the MP-BGP NH
resolution is referring to core routing instance for IP reachability. For a VPRN service this object
specifies the lookup to be used by the routing instance if no SDP to the destination exists.
ip-address[/mask] — Displays the specified tunnel table's destination IP address and mask.
Parameters
protocol protocol — Displays LDP protocol information.
sdp sdp-id — Displays information pertaining to the specified SDP.
summary — Displays summary tunnel table information.
Show Tunnel Table Output — The following table describes tunnel table output fields:
Output
Sample Output
*A:ALA-12>config>service# show router 3 tunnel-table
==============================================================================
Tunnel Table
==============================================================================
Destination
-------------------------------------------------------------------------------
10.0.0.1/32
10.0.0.1/32
10.0.0.1/32
10.0.0.1/32
==============================================================================
*A:ALA-12>config>service#
Page 790
Label
The route's destination address and mask.
Destination
Specifies the tunnel owner.
Owner
Specifies the tunnel's encapsulation type.
Encap
Specifies the tunnel (SDP) identifier.
Tunnel ID
Specifies the route preference for routes learned from the configured peer(s).
Pref
The next hop for the route's destination.
Nexthop
The route metric value for the route.
Metric
Owner
sdp
sdp
sdp
sdp
Encap Tunnel Id
GRE 10 5
GRE 21 5
GRE 31 5
GRE 41 5
Description
Pref NexthopMetric
10.0.0.1 0
10.0.0.1 0
10.0.0.1 0
10.0.0.1 0
7210-SAS M Services Guide