Alcatel-Lucent 7210 SAS M Service Manual page 893

Hide thumbs Also See for 7210 SAS M:
Table of Contents

Advertisement

7210 SAS M Services Guide
Label
Table Size
Total Count
Learned Count
Static Count
OAM-learned Count
Remote Age
Local Age
High Watermark
Low Watermark
Mac Learning
Discard Unknown
Mac Aging
Relearn Only
Mac Subnet Len
Source-Identifier
Type/Age
Description
Specifies the maximum number of learned and static entries
allowed in the FDB of this service.
Displays the total number of learned entries in the FDB of this
service.
Displays the current number of learned entries in the FDB of
this service.
Displays the current number of static entries in the FDB of this
service.
Displays the current number of OAM entries in the FDB of this
service.
Displays the number of seconds used to age out FDB entries
learned on an SDP. These entries correspond to MAC addresses
learned on remote SAPs.
Displays the number of seconds used to age out FDB entries
learned on local SAPs.
Displays the utilization of the FDB table of this service at
which a table full alarm will be raised by the agent.
Displays the utilization of the FDB table of this service at
which a table full alarm will be cleared by the agent.
Specifies whether the MAC learning process is enabled
Specifies whether frames received with an unknown destination
MAC are discarded.
Indicates whether the MAC aging process is enabled.
Displays, that when enabled, either the FDB table of this ser-
vice is full, or that the maximum system-wide number of
MA's supported by the agent has been reached, and thus MAC
learning is temporary disabled, and only MAC re-learns can
take place.
Displays the number of bits to be considered when performing
MAC-learning or MAC-switching.
The location where the MAC is defined.
Type — Specifies the number of seconds used to age out TLS
FDB entries learned on local SAPs.
Age — Specifies the number of seconds used to age out TLS
FDB entrieslearned on an SDP. These entries correspond to
MAC addresses learned on remote SAPs.
L — Learned - Dynamic entries created by the learning process.
OAM — Entries created by the OAM process.
VPLS Show Commands
Page 893

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents