Alcatel-Lucent 7210 SAS M Service Manual page 113

ccm-enable
Syntax [no] ccm-enable
Context config>port>ethernet>eth-cfm>mep
config>lag>eth-cfm>mep
This command enables the generation of CCM messages.
Description
The no form of the command disables the generation of CCM messages.
ccm-ltm-priority
Syntax ccm-ltm-priority priority
no ccm-ltm-priority
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
This command specifies the priority of the CCM and LTM messages transmitted by the MEP. Since
Description
CCM does not apply to the Router Facility MEP only the LTM priority is of value under that context.
The no form of the command reverts to the default values.
priority — Specifies the priority value
Default
eth-test-enable
Syntax [no] eth-test-enable
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
For this test to work, operators need to configure ETH-test parameters on both sender and receiver
Description
nodes. The ETH-test then can be done using the following OAM commands:
oam eth-cfm eth-test mac-address mep mep-id domain md-index association ma-index [priority
priority] [data-length data-length]
The no form of the command disables eth-test capabilities.
test-pattern
Syntax test-pattern {all-zeros | all-ones} [crc-enable]
no test-pattern
7210 SAS M Services Guide
0 — 7
Values
7
Default
Subscriber Services
Page 113