Alcatel-Lucent 7210 SAS M Service Manual page 184

Configuring a VLL Service with CLI
Distributed Epipe Service
Note: SDPs are not supported by 7210 SAS-M devices configured in Access Uplink mode.
To configure a distributed Epipe service, you must configure service entities on the originating
and far-end nodes. You should use the same service ID on both ends (for example, Epipe 5500 on
ALA-1 and Epipe 5500 on ALA-2). The spoke-sdp sdp-id:vc-id must match on both sides. A
distributed Epipe consists of two SAPs on different nodes.
By default QoS policy ID 1 is applied to ingress service SAPs. On egress, QoS policies are
associated with a port. Existing filter policies can be associated with service SAPs on ingress and
egress.
Meters (defined in sap-ingress policies) can be applied on ingress. It is associated with SAPs.
Scheduler Policies can be applied on egress. It is associated with a port.
Ingress and egress SAP parameters can be applied to local and distributed Epipe service SAPs.
For SDP configuration information, see
information, see
This example configures a distributed service between ALA-1 and ALA-2.
A:ALA-1>epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to east coast"
config>service>epipe# sap 221/1/3:21 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# qos 555
config>service>epipe>sap>ingress# filter ip 1
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# no shutdown
config>service>epipe>sap# exit
config>service>epipe#
A:ALA-2>config>service# epipe 5500 customer 5 create
config>service>epipe$ description "Distributed epipe service to west coast"
config>service>epipe# sap 441/1/4:550 create
config>service>epipe>sap# ingress
config>service>epipe>sap>ingress# filter ip 1020
config>service>epipe>sap>ingress# exit
config>service>epipe>sap# egress
config>service>epipe>sap>egress# filter ip 6
config>service>epipe>sap>egress# exit
config>service>epipe>sap# no shutdown
config>service>epipe#
The following example displays the SAP configurations for ALA-1 and ALA-2:
A:ALA-1>config>service# info
----------------------------------------------
...
Page 184
Configuring SDP Bindings on page
epipe 5500 customer 5 vpn 5500 create
description "Distributed epipe service to east coast"
sap 221/1/3:21 create
ingress
qos 555
filter ip 1
Configuring an SDP on page
189.
7210 SAS M Services Guide
71. For SDP binding