Vll Services Command Reference - Alcatel-Lucent 7210 SAS M Service Manual

VLL Services Command Reference

Command Hierarchies
Cpipe Service Configuration Commands
Note: Cpipe service configuration commands are not supported on 7210 SAS M devices
configured in access uplink mode.
config
7210 SAS M Services Guide
• Cpipe Service Configuration Commands on page 201
• Epipe Service Configuration Commands on page 203
— service
service-id [customer customer-id] [vpn vpn-id] [vc-type {satop-e1 | satop-t1 | cesopsn
— cpipe
| cesopsn-cas}] [create]
— no cpipe service-id
— description
— no description
— endpoint
— no endpoint
— sap
— sap
— no sap
— [no]
— service-mtu
— no service-mtu
description-string
[description-string]
endpoint-name [create]
endpoint-name
— active-hold-delay active-endpoint-delay
— no active-hold-delay
— description description-string
[description-string]
— no description
— revert-time revert-time infinite
— no revert-time
sap-id [no-endpoint] [create]
sap-id endpoint endpoint-name [create]
sap-id
service-name
— accounting-policy acct-policy-id
— no accounting-policy
— cem
jitter-buffer milliseconds [payload-size bytes]
— packet
— packet payload-size bytes
— no packet
— [no]
report-alarm
[underrun] [rpktloss] [rfault] [rrdi]
— [no]
rtp-header
— [no]
collect-stats
— description description-string
[description-string]
— no description
— ingress
— [no] [policy-id]
qos
octets
Virtual Leased Line Services
[acct-policy-id]
[stray] [malformed] [pktloss] [overrun]
Page 201