Alcatel-Lucent 7210 SAS M Service Manual page 395

address
Syntax address {ip-address/mask | ip-address netmask}
address ip-address mask
Context config>service>vpls>interface
This command assigns an IP address and an IP subnet, to a VPLS IP router interface. Only one IP
Description
address can be associated with an IP interface. An IP address must be assigned to each VPLS IP
interface. An IP address and a mask are used together to create a local IP prefix. The defined IP prefix
must be unique within the context of the routing instance. It cannot overlap with other existing IP
prefixes defined as local subnets on other IP interfaces in the same routing context within the 7210
SAS.
The IP address for the interface can be entered in either CIDR (Classless Inter-Domain Routing) or
traditional dotted decimal notation. The show commands display CIDR notation and is stored in
configuration files.
By default, no IP address or subnet association exists on an IP interface until it is explicitly created.
Use the no form of this command to remove the IP address assignment from the IP interface. When
the no address command is entered, the interface becomes operationally down.
The operational state is a read-only variable and the only controlling variables are the address and
admin states. The address and admin states are independent and can be set independently. If an
interface is in an adminstratively up state and an address is assigned, it becomes operationally up.
ip-address — The IP address of the IP interface. The ip-address portion of the address command
Parameters
/ — The forward slash is a parameter delimiter and separates the ip-address portion of the IP address
mask-length — The subnet mask length when the IP prefix is specified in CIDR notation. When the
7210 SAS M Services Guide
Address
No Address Up
No Address Down
1.1.1.1 Up
1.1.1.1 Down
specifies the IP host address that will be used by the IP interface within the subnet.
This address must be unique within the subnet and specified in dotted decimal notation. Allowed
values are IP addresses in the range 1.0.0.0 – 223.255.255.255 (with support of /31 subnets).
from the mask that defines the scope of the local subnet. No spaces are allowed between the
ipaddress, the "/" and the mask-length parameter. If a forward slash is not immediately following
the ip-address, a dotted decimal mask must follow the prefix.
IP prefix is specified in CIDR notation, a forward slash (/) separates the ip-address from the
mask-length parameter. The mask length parameter indicates the number of bits used for the
network portion of the IP address; the remainder of the IP address is used to determine the host
portion of the IP address. The values allowed are integers in the range 0 – 30. Note that a mask
length of 32 is reserved for system IP addresses.
Admin State Oper State
Down
Down
Up
Down
Virtual Private LAN Services
Page 395