Alcatel-Lucent 7210 SAS M Service Manual page 705

7210-SAS M Services Guide
Label
Service Destination Points (SDPs)
SDP Id
Type
Admin Path MTU
Oper Path MTU
Delivery
Admin State
Oper State
Ingress Label
Egress Label
Ingress Filter
Egress Filter
Far End
Last Changed
Signaling
Admin State
Oper State
Hello Time
Hello Msg Len
Max Drop Count
Hold Down Time
Description (Continued)
The SDP identifier.
Indicates whether this Service SDP binding is a spoke or a mesh.
The largest service frame size (in octets) that can be transmitted through
this SDP to the far-end router, without requiring the packet to be frag-
mented.
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Specifies the type of delivery used by the SDP: GRE or MPLS.
The administrative state of this SDP.
The operational state of this SDP.
The label used by the far-end device to send packets to this device in
this service by this SDP.
The label used by this device to send packets to the far-end device in
this service by this SDP.
The ID of the ingress filter policy.
The ID of the egress filter policy.
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
The date and time of the most recent change to this customer.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Specifies the operating status of the service.
The current status of the service.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the maximum number of consecutive SDP Echo Request mes-
sages that can be unacknowledged before the keepalive protocol reports
a fault.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
IES Show Commands
Page 705