Alcatel-Lucent 7210 SAS M Service Manual page 225

description-string — The description command accepts a description-string parameter. The
Parameters
collect-stats
Syntax [no] collect-stats
Context config>service>cpipe>sap
config>service>cpipe>spoke-sdp
config>service>epipe>sap
This command enables accounting and statistical data collection for either the SAP, network port, or
Description
IP interface. When applying accounting policies the data, by default, is collected in the appropriate
records and written to the designated billing file.
When the no collect-stats command is issued the statistics are still accumulated by the cards.
However, the CPU will not obtain the results and write them to the billing file. If a subsequent
collect-stats command is issued then the counters written to the billing file include all the traffic
while the no collect-stats command was in effect.
no collect-stats
Default
ethernet
Syntax ethernet
Context config>service>epipe>sap
Use this command to configure Ethernet properties in this SAP.
Description
llf
Syntax [no] llf
Context config>service>epipe>sap>ethernet
This command enables Link Loss Forwarding (LLF) on an Ethernet port. It provides an end-to-end
Description
OAM fault notification for Ethernet VLL service.LLF on an Ethernet port brings down the port when
there is a local fault on the pseudowire or service, or a remote fault on the SAP or pseudowire,
signaled with label withdrawal or TLDP status bits. It ceases when the fault disappears.
The Ethernet port must be configured for null encapsulation.
The no form of the command disables LLF.
7210 SAS M Services Guide
description-string parameter is an ASCII string of up to 80 characters in length. Only printable
127 bit ASCII characters are allowed. If the string contains spaces, the string must be specified
with beginning and ending quotes.
An ASCII string up to 80 characters in length.
Values
Virtual Leased Line Services
Page 225