Alcatel-Lucent 7210 SAS M Service Manual page 540

IES Interface Commands
A VPLS service associated with the specified name that does not have the allow-ip-int-binding flag
set or a non-VPLS service associated with the name will be ignored and will not be attached to the IP
interface.
If the service name is applied to a VPLS service after the service name is bound to an IP interface and
the VPLS service allow-ip-int-binding flag is set at the time the name is applied, the VPLS service is
automatically resolved to the IP interface if the interface is administratively up or when the interface
is placed in the administratively up state.
If the service name is applied to a VPLS service without the allow-ip-int-binding flag set, the system
does not attempt to resolve the applied service name to an existing IP interface bound to the name. To
rectify this condition, the flag must first be set and then the IP interface must enter or reenter the
administratively up state.
While the specified service name may be assigned to only one service context in the system, it is
possible to bind the same service name to more than one IP interface. If two or more IP interfaces are
bound to the same service name, the first IP interface to enter the administratively up state (if
currently administratively down) or to reenter the administratively up state (if currently
administratively up) when a VPLS service is configured with the name and has the allow-ip-
intbinding flag set will be attached to the VPLS service. Only one IP interface is allowed to attach to
a VPLS service context. No error is generated for the remaining non-attached IP interfaces using the
service name.
Once an IP interface is attached to a VPLS service, the name associated with the service cannot be
removed or changed until the IP interface name binding is removed. Also, the allow-ip-int-binding
flag cannot be removed until the attached IP interface is unbound from the service name. Unbinding
the service name from the IP interface causes the IP interface to detach from the VPLS service
context. The IP interface may then be bound to another service name or a SAP or SDP binding may
be created for the interface using the sap or spoke-sdp commands on the interface.
none
Default
service-name — The service-name parameter is required when using the IP interface vpls command
Parameters
and specifies the service name that the system will attempt to resolve to an allow-ip-int-binding
enabled VPLS service associated with the name. The specified name is expressed as an ASCII string
comprised of up to 32 characters. It does not need to already be associated with a service and the
system does not check to ensure that multiple IP interfaces are not bound to the same name.
ingress
Syntax ingress
Context config>service>ies>if>vpls
The ingress node in this context under the vpls binding is used to define the routed ip-filter-id
Description
optional filter overrides.
v4-routed-override-filter
Syntax v4-routed-override-filter ip-filter-id
Page 540 7210-SAS M Services Guide