Alcatel-Lucent 7210 SAS M Service Manual page 828

Show, Clear, Debug Commands
base
Syntax base
Context show>service>id
Displays basic information about the service ID including service type, description, SAPs.
Description
Show Service-ID Base — The following table describes show service-id base output fields:
Output
Page 828
Label
Service Id
Vpn Id
Service Type
Description
Customer Id
Last Mgmt Change
Adm
Oper
Mtu
Def. Mesh VC Id
SAP Count
SDP Bind Count
Identifier
Type
AdmMTU
PBB Tunnel Point
Admin MTU
Backbone-Flooding
The service identifier.
Specifies the VPN ID assigned to the service.
The type of service: Epipe, VPLS
Generic information about the service.
The customer identifier.
The date and time of the most recent management-initiated change to
this customer.
The desired state of the service.
The operating state of the service.
The largest frame size (in octets) that the service can handle.
This object is only valid in services that accept mesh SDP bindings. It
is used to validate the VC ID portion of each mesh SDP binding
defined in the service.
The number of SAPs defined on the service.
The number of SDPs bound to the service.
Specifies the service access (SAP) points.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received.
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SAP, without requiring the packet to be frag-
mented.
Specifies the endpoint in the B-VPLS environment where the Epipe
terminates.
Specifies the B-VPLS admin MTU.
Specifies whether or not the traffic is flooded in the B-VPLS for the
detination instead of unicast. If the backbone destination MAC is in the
B-VPLS FDB, then it will be unicast.
Description
7210 SAS M Services Guide