Alcatel-Lucent 7210 SAS M Service Manual page 538

IES Interface Commands
delayed-enable
Syntax delayed-enable seconds [init-only]
no delayed-enable
Context config>service>ies>if
This command delays making interface operational by the specified number of seconds. In
Description
environments with many subscribers, it can take time to synchronize the subscriber state between
peers when the subscriber-interface is enabled (perhaps, after a reboot). To ensure that the state has
time to be synchronized, the delayed-enable timer can be specified. The optional parameter init-only
can be added to use this timer only after a reboot.
no delayed-enable
Default
seconds — Specifies the number of seconds to delay before the interface is operational.
Parameters
ip-mtu
Syntax ip-mtu octets
no ip-mtu
Context config>service>ies>if
This command configures the maximum IP transmit unit (packet) for the interface.
Description
The MTU that is advertized from the IES size is:
MINIMUM((SdpOperPathMtu - EtherHeaderSize), (Configured ip-mtu))
By default (for Ethernet network interface) if no ip-mtu is configured, the packet size is (1568 - 14) =
1554.
The no form of the command returns the default value.
no ip-mtu
Default
octets — pecifies the number of octets in the IP-MTU.
Parameters
loopback
Syntax [no] loopback
Context config>service>ies>if
This command specifies that the associated interface is a loopback interface that has no associated
Description
physical interface. As a result, the associated IES interface cannot be bound to a SAP.
Note that you can configure an IES interface as a loopback interface by issuing the loopback
Page 538
1 — 1200
Values
512 — 9000
Values
7210-SAS M Services Guide