Alcatel-Lucent 7210 SAS M Service Manual page 232

VLL Service Configuration Commands
qos
Syntax qos policy-id
no qos
Context config>service>cpipe>sap>ingress
config>service>epipe>sap>ingress
This command associates a Quality of Service (QoS) policy with an ingress Service Access Point
Description
(SAP).
QoS ingress policies are important for the enforcement of SLA agreements. The policy ID must be
defined prior to associating the policy with a SAP or IP interface. If the policy-id does not exist, an
error will be returned.
The qos command is used to associate ingress . The qos command only allows ingress policies to be
associated on SAP ingress. Attempts to associate a QoS policy of the wrong type returns an error.
Only one ingress QoS policy can be associated with a SAP or IP interface at one time. Attempts to
associate a second QoS policy of a given type will return an error.
By default, if no specific QoS policy is associated with the SAP for ingress, so the default QoS policy
is used.
The no form of this command removes the QoS policy association from the SAP, and the QoS policy
reverts to the default.
policy-id — The ingress policy ID to associate with SAP on ingress. The policy ID must already exist.
statistics
Syntax statistics
Context config>service>epipe>sap
config>service>vpls>sap
This command enables the context to configure the counters associated with SAP ingress and egress.
Description
ingress
Syntax ingress
Context config>service>epipe>sap>statistics
config>service>vpls>sap>statistics
This command enables the context to configure the ingress SAP statistics counter.
Description
Page 232
1 — 65535
Values
7210 SAS M Services Guide