Alcatel-Lucent 7210 SAS M Service Manual page 546

Hide thumbs Also See for 7210 SAS M:

Table of Contents

IES Filter Commands

filter ip ip-filter-id

config>service>ies>if>sap>egress

config>service>ies>if>sap>ingress

This command associates a filter policy with an ingress or egress Service Access Point (SAP). Filter

policies control the forwarding and dropping of packets based on the matching criteria.

The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress or

egress SAP. The filter policy must already be defined before the filter command is executed. If the

filter policy does not exist, the operation will fail and an error message returned.

In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception

is non-IP packets are not applied to the match criteria, so the default action in the filter policy applies

to these packets.

The no form of this command removes any configured filter ID association with the SAP. The filter

ID itself is not removed from the system.

IES — Only IP filters are supported on an IES IP interface, and the filters only apply to routed

Special Cases

ip — Keyword indicating the filter policy is an IP filter.

ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the range of 1

config>service>ies>if>sap

This command enables the context to apply egress policies.

and 65535 that corresponds to a previously created IP filter policy in the configure>filter>ip-

filter context.

7210-SAS M Services Guide

Show Quick Links

Table of Contents