Alcatel-Lucent 7210 SAS M Service Manual page 419

Hide thumbs Also See for 7210 SAS M:

Table of Contents

VPLS Filter and QoS Policy Commands

config>service>vpls>sap

This command enables the context to configure egress filter policies.

If no egress filter is defined, no filtering is performed.

config>service>vpls>sap

This command enables the context to configure ingress SAP Quality of Service (QoS) policies and

filter policies.

If no sap-ingress QoS policy is defined, the system default sap-ingress QoS policy is used for ingress

processing. If no ingress filter is defined, no filtering is performed.

filter ip ip-filter-id

filter ipv6 ipv6-filter-id

filter mac mac-filter-id

config>service>vpls>sap>egress

config>service>vpls>sap>ingress

config>service>vpls>spoke-sdp>egress

This command associates an IP filter policy or MAC filter policy with an ingress or egress Service

Access Point (SAP) or IP interface.

Filter policies control the forwarding and dropping of packets based on IP or MAC matching criteria.

There are two types of filter policies: IP and MAC. Only one type may be applied to a SAP at a time.

The filter command is used to associate a filter policy with a specified filter ID with an ingress or

egress SAP. The filter ID must already be defined before the filter command is executed. If the filter

policy does not exist, the operation will fail and an error message returned.

In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception

is non-IP packets are not applied to IP match criteria, so the default action in the filter policy applies

to these packets.

The no form of this command removes any configured filter ID association with the SAP or IP

interface. The filter ID itself is not removed from the system.

7210 SAS M Services Guide

Virtual Private LAN Services

Show Quick Links

Table of Contents