Alcatel-Lucent 7210 SAS M Service Manual page 869

7210 SAS M Services Guide
Label
Oper Path MTU
Far End
Delivery
Admin State
Oper State
Ingress Label
Egress Label
Last Changed
Signaling
Admin State
Oper State
Hello Time
Max Drop Count
Hello Msg Len
Hold Down Time
I. Fwd. Pkts.
I. Dro. Pkts
E. Fwd. Pkts.
E. Fwd. Octets
Associated LSP
List
Description (Continued)
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Specifies the IP address of the remote end of the MPLS tunnel defined
by this SDP.
Specifies the type of delivery used by the SDP: MPLS.
The administrative state of this SDP.
The operational state of this SDP.
The label used by the far-end device to send packets to this device in
this service by this SDP.
The label used by this device to send packets to the far-end device in
this service by the SDP.
The date and time of the most recent change to the SDP.
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
The administrative state of the Keepalive process.
The operational state of the Keepalive process.
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol
reports a fault.
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
Specifies the number of forwarded ingress packets.
Specifies the number of dropped ingress packets.
Specifies the number of forwarded egress packets.
Specifies the number of forwarded egress octets.
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS.
VPLS Show Commands
Page 869