Alcatel-Lucent 7210 SAS M Service Manual page 339

Use the following CLI syntax to create a load balancing across two management VPLS instances:
CLI Syntax: config>service# sdp sdp-id mpls create
CLI Syntax: vpls service-id customer customer-id [m-vpls] create
This following output shows example configurations for load balancing across two protected
VPLS spoke SDPs:
The configuration on ALA-A (SAS-M) is shown below.
# MVPLS 100 configs
*A:ALA-A# configure service vpls 100
*A:ALA-A>config>service>vpls# info
----------------------------------------------
----------------------------------------------
*A:ALA-A>config>service>vpls#
# UVPLS 101 configs
*A:ALA-A>config>service# vpls 101
*A:ALA-A>config>service>vpls# info
----------------------------------------------
7210 SAS M Services Guide
far-end ip-address
lsp lsp-name
no shutdown
description description-string
spoke-sdp sdp-id:vc-id create
stp
path-cost
stp
no shutdown
description "Default tls description for service id 100"
stp
no shutdown
exit
sap lag-3:100 create
description "Default sap description for service id 100"
managed-vlan-list
range 101-110
exit
exit
spoke-sdp 1201:100 create
stp
path-cost 100
exit
exit
spoke-sdp 1401:100 create
exit
no shutdown
description "Default tls description for service id 101"
sap lag-3:101 create
description "Default sap description for service id 101"
exit
spoke-sdp 1201:101 create
Virtual Private LAN Services
Page 339