Alcatel-Lucent 7210 SAS M Service Manual page 420

Virtual Private LAN Services
VPLS — Both MAC and IP filters are supported on a VPLS service SAP.
Special Cases
ip ip-filter-id — Specifies IP filter policy. The filter ID must already exist within the created IP filters.
Parameters
ipv6 ipv6-filter-id — Specifies the IPv6 filter policy. The filter ID must already exist within the
mac mac-filter-id — Specifies the MAC filter policy. The specified filter ID must already exist within
qos
Syntax qos policy-id
no qos
Context config>service>vpls>sap>ingress
This command associates a Quality of Service (QoS) policy with an ingress Service Access Point
Description
(SAP) or IP interface.
QoS ingress policies are important for the enforcement of SLA agreements. The policy ID must be
defined prior to associating the policy with a SAP. If the policy-id does not exist, an error will be
returned.
The qos command is used to associate ingress apolicies. The qos command only allows ingress
policies to be associated on SAP ingress. Attempts to associate a QoS policy of the wrong type
returns an error.
Only one ingress QoS policy can be associated with a SAP at one time. Attempts to associate a
second QoS policy of a given type will return an error.
By default, if no specific QoS policy is associated with the SAP for ingress , so the default QoS policy
is used.
The no form of this command removes the QoS policy association from the SAP, and the QoS policy
reverts to the default.
policy-id — The ingress policy ID to associate with SAP on ingress. The policy ID must already exist.
aggregate-meter-rate
Syntax aggregate-meter-rate rate-in-kbps [burst burst-in-kbits]
no aggregate-meter-rate
Context config>service> vpls> sap> ingress
config>service>epipe> sap> ingress
Page 420
1 — 65535
Values
created IPv6 filters.
1 — 65535
Values
the created MAC filters. The filter policy must already exist within the created MAC filters.
1 — 65535
Values
1 — 65535
Values
7210 SAS M Services Guide