Alcatel-Lucent 7210 SAS M Service Manual page 530

IES Global Commands
This command specifies whether "packet-too-big" ICMPv6 messages should be sent. When enabled,
Description
ICMPv6 "packet-too-big" messages are generated by this interface.
The no form of the command disables the sending of ICMPv6 "packet-too-big" messages.
100 10
Default
number — Specifies the number of "packet-too-big" ICMPv6 messages to send in the time frame
Parameters
seconds — Specifies the time frame in seconds that is used to limit the number of "packet-too-big"
param-problem
Syntax param-problem [number seconds]
no packet-too-big
Context config>service>ies>if>ipv6>icmp6
This command specifies whether "parameter-problem" ICMPv6 messages should be sent. When
Description
enabled', "parameter-problem" ICMPv6 messages are generated by this interface.
The no form of the command disables the sending of "parameter-problem" ICMPv6 messages.
100 10
Default
number — Specifies the number of "parameter-problem" ICMPv6 messages to send in the time
seconds — Specifies the time frame in seconds that is used to limit the number of "parameter-
redirects
Syntax redirects [number seconds]
no redirects
Context config>service>ies>if>ipv6>icmp6
Page 530
specified by the seconds parameter.
10 — 1000
Values
100
Default
ICMPv6 messages issued.
1 — 60
Values
10
Default
frame specified by the seconds parameter.
10 — 1000
Values
100
Default
problem" ICMPv6 messages issued.
1 — 60
Values
10
Default
7210-SAS M Services Guide