Figure 13: Ethernet Oam Model For Broadband Access - Residential; Figure 14: Ethernet Oam Model For Broadband Access - Wholesale - Alcatel-Lucent 7210 SAS M Service Manual

ETH-CFM capabilities may be deployed in many different Ethernet service architectures. The
Ethernet based SAPs and SDP bindings provide the endpoint on which the management points
may be created. The basic functions can be used in different services, VPLS and Epipe . The ETH-
CFM functionality is also applicable to broadband access networks. Two models of broadband
access are shown below to illustrate how ETH-CFM could be deployed in these cases.
and Figure
Customer

Figure 13: Ethernet OAM Model for Broadband Access - Residential

Customer

Figure 14: Ethernet OAM Model for Broadband Access - Wholesale

As shown in
7210 SAS M Services Guide
14).
(e2e) RG to BNG ME (Customer)
Access Port BNG ME Carrier)
Access Link ME
Access
Node
(e2e) RG to BNG ME (Customer)
Access Port to Agg Node (Short Carrier)
Access Link ME
Access
Node
Figure 16 and Figure
Ethernet
Access
Network
Aggregation
Node
NNI
Ethernet
Access
Network
Aggregation
Node
17, the following functions are supported:
Services
MEP
MIP
Regional Network
BNG
Fig_11-7210
MEP
MIP
Regional Network
BNG
Fig_12-7210
Page 75
(Figure 13