Alcatel-Lucent 7210 SAS M Service Manual page 114

ETH-CFM Configuration Commands
Context config>port>ethernet>eth-cfm>mep>eth-test>
config>lag>eth-cfm>mep>eth-test>
config>router>if>eth-cfm>mep>eth-test
This command specifies the test pattern of the ETH-TEST frames. This does not have to be
Description
configured the same on the sender and the receiver.
The no form of the command reverts to the default values.
all-zeros — Specifies to use all zeros in the test pattern.
Parameters
all-ones — Specifies to use all ones in the test pattern.
crc-enable — Generates a CRC checksum.
low-priority-defect
Syntax low-priority-defect {allDef | macRemErrXcon | remErrXcon | errXcon | xcon | noXcon}
Context config>port>ethernet>eth-cfm>mep>eth-test>
config>lag>eth-cfm>mep>eth-test>
This command specifies the lowest priority defect that is allowed to generate a fault alarm. This
Description
setting is also used to determine the fault state of the MEP which, well enabled to do so, causes a
network reaction.
macRemErrXcon
Default
mac-address
Syntax mac-address mac-address
no mac-address
Context config>port>ethernet>eth-cfm>mep>
config>lag>eth-cfm>mep>
config>router>if>eth-cfm>mep
This command specifies the MAC address of the MEP.
Description
The no form of the command reverts to the MAC address of the MEP back to the default, that of the
port, since this is SAP based.
Page 114
all-zeros
Default
allDef
Values
macRemErrXcon
remErrXcon Only DefRemoteCCM, DefErrorCCM, and DefXconCCM
errXcon
xcon
noXcon
DefRDICCM, DefMACstatus, DefRemoteCCM, DefErrorCCM,
and DefXconCCM
Only DefMACstatus, DefRemoteCCM, DefErrorCCM, and
DefXconCCM
Only DefErrorCCM and DefXconCCM
Only DefXconCCM; or
No defects DefXcon or lower are to be reported
7210 SAS M Services Guide