Common CLI Command Descriptions
Common Service Commands
SAP syntax
sap
Syntax
[no] sap sap-id
Description
This command specifies the physical port identifier portion of the SAP definition.
Parameters
sap-id — Specifies the physical port identifier portion of the SAP definition.
The sap-id can be configured in one of the following formats:
Type
port-id
slot/mda/port[.channel]
null
[port-id | lag-id]
dot1q
[port-id | lag-id]:qtag1
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If this
parameter is not specificially defined, the default value is 0.
Values
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Port Type
Encap-Type
Ethernet
Null
Ethernet
Dot1q
Page 162
Syntax
qtag1:
* | 0 — 4094
qtag2 :
* | 0 — 4094
Allowed Values
0
0 — 4094
7210 SAS M, X Router Configuration Guide
1/1/5
port-id: 1/1/3
lag-id: lag-3
port-id:qtag1: 1/1/3:100
lag-id:lag-1:102
Comments
The SAP is identified by the port.
The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
Example