Alcatel-Lucent 7210 SAS M Service Manual page 890

Show, Clear, Debug Commands
base
Syntax base [msap]
Context show>service>id
show>service>id>igmp-snooping
This command displays basic information about the service ID including service type, description,
Description
SAPs and SDP.
Show Service-ID Base — The following table describes show service-id base output fields:
Output
Page 890
Label
Expiry
Interface
SAP
Label
Service Id
Service Type
Description
Customer Id
Last Mgmt Change
Adm
Oper
Mtu
Adm
SAP Count
Identifier
OprMTU
Opr
Other — Local entries for the IP interfaces created.
The age of the ARP entry.
The interface applied to the service.
The SAP ID.
The service identifier.
Displays the type of service.
Generic information about the service.
The customer identifier.
The date and time of the most recent management-initiated change to
this customer.
The administrative state of the service.
The operational state of the service.
The largest frame size (in octets) that the port can handle.
The largest frame size (in octets) that the SAP can handle.
The number of SAPs defined on the service.
Specifies the service access (SAP).
Specifies the actual largest service frame size (in octets) that can be
transmitted through this port, without requiring the packet to be frag-
mented.
The operating state of the SAP
Description
Description
7210 SAS M Services Guide