Alcatel-Lucent 7210 SAS M Service Manual page 110

SDP Keepalive Commands
This command configures the number of consecutive SDP keepalive failed request attempts or remote
Description
replies that can be missed after which the SDP is operationally downed. If the max-drop-count
consecutive keepalive request messages cannot be sent or no replies are received, the SDP-ID will be
brought operationally down by the keepalive SDP monitoring.
The no form of this command reverts the max-drop-count count value to the default settings.
Default max-drop-count 3
count — The number of consecutive SDP keepalive requests that are failed to be sent or replies
Parameters
message-length
Syntax message-length octets
no message-length
Context config>service>sdp>keep-alive
This command configures the SDP monitoring keepalive request message length transmitted.
Description
The no form of this command reverts the message-length octets value to the default setting.
0 — The message length should be equal to the SDP's operating path MTU as configured in the path-
Default
mtu command. If the default size is overridden, the actual size used will be the smaller of the
operational SDP-ID Path MTU and the size specified.
octets — The size of the keepalive request messages in octets, expressed as a decimal integer. The
timeout
Syntax timeout timeout
no timeout
Context config>service>sdp>keep-alive
This command configures the time interval that the SDP waits before tearing down the session.
Description
5
Default
timeout — The timeout time, in seconds.
Parameters
Page 110
missed, expressed as a decimal integer.
1 — 5
Values
size keyword overrides the default keepalive message size.
40 — 9198
Values
1 — 10
Values
7210 SAS M Services Guide