Alcatel-Lucent 7210 SAS M Service Manual page 535

IES Interface Commands
interface
Syntax interface ip-int-name
no interface ip-int-name
Context config>service>ies
This command creates a logical IP routing interface for an Internet Enhanced Service (IES). Once
Description
created, attributes like an IP address and service access point (SAP) can be associated with the IP
interface.
The interface command, under the context of services, is used to create and maintain IP routing
interfaces within IES service IDs. The interface command can be executed in the context of an IES
service ID. The IP interface created is associated with the service core network routing instance and
default routing.
Interface names are case sensitive and must be unique within the group of defined IP interfaces
defined for config service ies interface (that is, the network core router instance). Interface names
must not be in the dotted decimal notation of an IP address. For example, the name "1.1.1.1" is not
allowed, but "int-1.1.1.1" is allowed. Show commands for router interfaces use either interface names
or the IP addresses. Use unique IP address values and IP address names to maintain clarity. It could
be unclear to the user if the same IP address and IP address name values are used. Although not
recommended, duplicate interface names can exist in different router instances.
When a new name is entered, a new logical router interface is created. When an existing interface
name is entered, the user enters the router interface context for editing and configuration.
By default, there are no default IP interface names defined within the system. All IES IP interfaces
must be explicitly defined. Interfaces are created in an enabled state.
The no form of this command removes IP the interface and all the associated configuration. The
interface must be administratively shutdown before issuing the no interface command.
For IES services, the IP interface must be shutdown before the SAP on that interface may be
removed.
ip-int-name — Specifies the name of the IP interface. Interface names must be unique within the
Parameters
7210-SAS M Services Guide
group of defined IP interfaces for config router interface and config service ies interface
commands. An interface name cannot be in the form of an IP address. Interface names can be
from 1 to 32 alphanumeric characters. If the string contains special characters (#, $, spaces, etc.),
the entire string must be enclosed within double quotes.
If ip-int-name already exists within the service ID, the context will be changed to maintain that
IP interface. If ip-int-name already exists within another service ID, an error will occur and
context will not be changed to that IP interface. If ip-int-name does not exist, the interface is
created and context is changed to that interface for further command processing.
IES Service Configuration Commands
Page 535