Alcatel-Lucent 7210 SAS M Service Manual page 541

Hide thumbs Also See for 7210 SAS M:

Table of Contents

no v4-routed-override-filter

config>service>ies>if>vpls>ingress

The v4-routed-override-filter command is used to specify an IP filter ID that is applied to all ingress

packets entering the VPLS service. The filter overrides any existing ingress IP filter applied to SAPs

or SDP bindings for packets associated with the routing IP interface. The override filter is optional

and when it is not defined or it is removed, the IP routed packets uses the any existing ingress IP filter

on the VPLS virtual port.

The no form of the command is used to remove the IP routed override filter from the ingress IP

interface. When removed, the IP ingress routed packets within a VPLS service attached to the IP

interface uses the IP ingress filter applied to the packets virtual port when defined.

ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the range of 1

7210-SAS M Services Guide

and 65535 that corresponds to a previously created IP filter policy in the configure>filter>ip-

filter context.

IES Service Configuration Commands

Show Quick Links

Table of Contents