Alcatel-Lucent 7210 SAS M Service Manual page 220

VLL Service Configuration Commands
octets — The size of the MTU in octets, expressed as a decimal integer, between 1 — 9194.
service-name
Syntax service-name service-name
no service-name
Context config>service>epipe
config>service>cpipe
This command configures an optional service name, up to 64 characters in length, which adds a name
Description
identifier to a given service to then use that service name in configuration references as well as
display and use service names in show commands throughout the system. This helps the service
provider/administrator to identify and manage services within the 7750 SR, 7450 ESS and 7710 SR
platforms.
All services are required to assign a service ID to initially create a service. However, either the service
ID or the service name can be used o identify and reference a given service once it is initially created.
service-name — Specifies a unique service name to identify the service. Service names may not begin
Parameters
service-mtu-check
Note:This command is supported on 7210 SAS-M in Network mode.
Syntax [no] service-mtu-check
Context config>service>epipe
The no form of this command disables the service MTU check.
Description
Disabling service MTU check allows the packets to pass to the egress if the packet length is lesser
than or equal to the MTU configured on the port. The length of the packet sent from a SAP is limited
only by the access port MTU. In case of a pseudowire the length of a packet is limited by the network
port MTU (including the MPLS encapsulation).
Page 220
SAP VC-Type
Ethernet
Ethernet (with preserved dot1q)
VPLS
VPLS (with preserved dot1q)
VLAN (dot1p transparent to MTU value)
VLAN (Q-in-Q with preserved bottom Qtag)
with an integer (0-9).
Example Advertised
Service MTU
1514
1518
1514
1518
1514
1518
7210 SAS M Services Guide
MTU
1500
1504
1500
1504
1500
1504