Alcatel-Lucent 7210 SAS M Service Manual page 433

seconds — Specifies the length of time to wait to receive a response to the host-query message from
Parameters
report-src-ip
Syntax report-src-ip-address
no report-src-ip
Context config>service>vpls>igmp-snooping
This parameter specifies the source IP address used when generating IGMP reports. According the
Description
IGMPv3 standard, a zero source address is allowed in sending IGMP reports. However, for
interoperability with some multicast routers, the source IP address of IGMP group reports can be
configured using this command.
0.0.0.0
Default
ip-address — The source IP source address in transmitted IGMP reports.
Parameters
robust-count
Syntax robust-count robust-count
no robust-count
Context config>service>vpls>igmp-snooping
config>service>vpls>sap>igmp-snooping
config>service>vpls>spoke-sdp>igmp-snooping
config>service>vpls>mesh-sdp>igmp-snooping
config>service>pw-template>igmp-snooping
If the send-queries command is enabled, this parameter allows tuning for the expected packet loss on
Description
a SAP or SDP. The robust-count variable allows tuning for the expected packet loss on a subnet and is
comparable to a retry count. If this SAP or SDP is expected to be 'lossy', this parameter may be
increased. IGMP snooping on this SAP or SDP is robust to (robust-count-1) packet losses.
If send-queries is not enabled, this parameter will be ignored.
2
Default
robust-count — Specifies the robust count for the SAP or SDP.
Parameters
7210 SAS M Services Guide
the host.
1 — 1023
Values
config>service>vpls>sap>igmp-snooping: 2— 7
Values
config>service>vpls>igmp-snooping: 1 — 255
config>service>vpls>spoke->sdp>igmp-snooping: 2— 7
config>service>vpls>mesh-sdp>igmp-snooping: 2— 7
Virtual Private LAN Services
Page 433