Configuring The Attributes Of Data To Be Sent To Radius Servers - H3C S3100 Series Operation Manual

Configuring the Attributes of Data to be Sent to RADIUS Servers

Table 2-19 Configure the attributes of data to be sent to RADIUS servers
Operation
Enter system view
Create a RADIUS scheme
and enter its view
Set the format of the user
names to be sent to
RADIUS server
Set the units of data flows
to RADIUS servers
Set the MAC address
format of the
Calling-Station-Id (Type 31)
field in RADIUS packets
Set the RADIUS
source IP scheme
address of view
outgoing
System
RADIUS
view
messages
Command
system-view
radius scheme
radius-scheme-name
user-name-format
{ with-domain |
without-domain }
data-flow-format data { byte |
giga-byte | kilo-byte |
mega-byte } packet
{ giga-packet | kilo-packet |
mega- packet | one-packet }
calling-station-id mode
{ mode1 | mode2 } { lowercase
| uppercase }
nas-ip { ip-address | ipv6
ipv6-address }
radius nas-ip { ip-address |
ipv6 ipv6-address }
2-20
Remarks
—
Required
By default, a RADIUS scheme
named "system" has already been
created in the system.
Optional
By default, the user names sent
from the switch to RADIUS server
carry ISP domain names.
Optional
By default, in a RADIUS scheme,
the data unit and packet unit for
outgoing RADIUS flows are byte
and one-packet respectively.
Optional
By default, the MAC address
format is XXXX-XXXX-XXXX, in
lowercase.
Optional
By default, no source IP address is
set; and the IP address of the
corresponding outbound interface
is used as the source IP address.