Server-Type - H3C S5120-SI Series Command Reference Manual

Parameters
ip-address: IPv4 address of the secondary authentication/authorization server, in dotted decimal
notation. The default is 0.0.0.0.
port-number: UDP port number of the secondary authentication/authorization server, which ranges from
1 to 65535 and defaults to 1812.
Description
Use the secondary
authentication/authorization server.
Use the undo secondary authentication command to remove the configuration.
By default, no secondary RADIUS authentication/authorization server is specified.
Note that:
The IP addresses of the primary and secondary authentication/authorization servers cannot be the
same. Otherwise, the configuration fails.
The RADIUS service port configured on the device and that of the RADIUS server must be
consistent.
You can use the commands to change the settings only when no user is using the RADIUS
scheme.
Related commands: key, radius scheme, state.
Examples
# Specify the secondary authentication/authorization server for RADIUS scheme radius1.
<Sysname> system-view
[Sysname] radius scheme radius1
[Sysname-radius-radius1] secondary authentication 10.110.1.2 1812

server-type

Syntax
server-type { extended | standard }
undo server-type
View
RADIUS scheme view
Default Level
2: System level
Parameters
extended: Specifies the extended RADIUS server (generally iMC), which requires the RADIUS client
and RADIUS server to interact according to the procedures and packet formats provisioned by the
private RADIUS protocol.
authentication command
2-22
to specify the secondary RADIUS