Ip Load Bgp - Alcatel-Lucent 060321-10, Rev. B Cli Reference Manual

ip load bgp

ip load bgp
Loads the BGP protocol software into running memory on the router. The image file containing BGP
should already be resident in flash memory before issuing this command.
ip load bgp
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 10K
Usage Guidelines
•
This command requires that the BGP software be resident in flash memory in the active directory.
•
Enter this command in the router's configuration file (boot.cfg) to ensure BGP software is running after
a reboot.
•
The command does not administratively enable BGP on the router; BGP will be disabled after issuing
this command. You must issue the
Examples
-> ip load bgp
Release History
Release 7.1.1; command was introduced.
Related Commands
ip bgp autonomous-system
ip bgp admin-state
MIB Objects
alaDrcTmIPBgpStatus
page 19-6
ip bgp admin-state to start the BGP protocol.
Configures the Autonomous system number for this BGP router.
Administratively enables or disables BGP.
OmniSwitch CLI Reference Guide
BGP Commands
March 2011