Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual page 61

Copyright © 2010, Juniper Networks, Inc.
Table 4: Interface Types and Specifiers for E120 Router and E320
Router (continued)
Interface Type Description
sonet – section Section layer
layer of a
SONET/SDH
interface
tenGigabitEthernet IEEE 802.3ae
10-Gigabit
Ethernet
(GE)
interface
Chapter 1: Command Reference Topics
Interface Specifier
slot/adapter/port
slot—Number of the chassis slot in the range
0–5 (E120 router) and 0–5 or 11–16 (E320
router)
adapter—Identifier for the IOA within the
chassis slot, either 0 or 1, where:
0 indicates that the IOA is installed in the
right IOA bay (E120 router) or the upper IOA
bay (E320 router).
1 indicates that the IOA is installed in the
left IOA bay (E120 router) or the lower IOA
bay (E320 router).
port—Port number on the IOA
slot/adapter/port[.subinterface1[.subinterface2
] ]
slot—Number of the chassis slot in the range
0–5 (E120 router) and 0–5 or 11–16 (E320
router)
adapter—Identifier for the IOA within the
chassis slot. 0 indicates that this a full-height
IOA.
port—Port number on the IOA
The meaning of the subinterface variables
depends on the configuration context. You can
configure 10-Gigabit Ethernet interfaces with or
without VLANs.
VLANs:
subinterface1—Number of the VLAN
subinterface in the range 1–2147483647;
no more than 4096 VLAN subinterfaces
per 10-Gigabit Ethernet physical port
subinterface2—When using PPPoE, the
number of the PPPoE subinterface in the
range 1–2147483647; no more than 16,000
PPPoE subinterfaces per 10-Gigabit
Ethernet line module
No VLANs:
subinterface1—When using PPPoE, the
number of the PPPoE subinterface in the
range 1–2147483647; no more than 16,000
PPPoE subinterfaces per 10-Gigabit
Ethernet line module
subinterface2—Not used
Example
sonet 3/0/0
tenGigabitEthernet
4/0/1.20
17