Hot-Swapping A Card - H3C SR6600 Fundamentals Configuration Manual

To do...
Bind the execution time with the
commands in the task, that is,
configure the time to execute the
commands in the task
Only one view can be specified for a task, which means all commands in the task are executed in
the same specified view. If different views are specified by executing the view view-name
command repeatedly, only the last configuration takes effect.
The view must be currently supported by the system, with its name specified using its complete
format but not an abbreviation. Most commonly used view names include: monitor for user view,
system for system view, GigabitEtherentx/x/x for Ethernet interface view, and Vlan-interfacex
for VLAN interface view.
timeID is used to uniquely identify the binding between a command and its execution time. A
scheduled task can contain up to 10 commands.
The command specified by the command command argument must be a command that can be
executed in the view specified by the view view-name command; otherwise this command cannot
be automatically executed. Therefore, ensure the correctness of the configuration.

Hot-Swapping a Card

To install a hot swappable card on a device, you can insert it into a slot of the device directly.
When the device is running, you can use the following command to unmount a hot swappable card, and
then remove it:
Follow the step to unmount a hot swappable card:
To do...
Unmount a hot
swappable card
or its sub card
time timeID at time1 date
command command
time timeID { one-off | repeating }
at time1 [ month-date month-day |
week-day week-daylist ]
command command
time timeID { one-off | repeating }
delay time2 command command
A centralized
remove slot slot-number
device
remove slot slot-number [ subslot
A distributed
device subslot-number ]
Use the command...
Use the command...
13-160
Remarks
Required
Use any of the commands.
Remarks
Optional
Available in user view.
Optional
Available in user view,