Installing A Cf Card; Installing A Power Supply - H3C SR6604 Installation Manual

3. Fasten the captive screws on the fan tray.
4. Power on the router and check the status LED on the front panel.
On means the fan tray is operating correctly. Off means the fan tray has failed the POST. For
the LED description of the fan tray, see H3C SR6604[6608] Routers Hardware Information and
Specifications.

Installing a CF card

To install a CF card on an MCP, remove the CF card cover first.
To install a CF card:
1. Push the CF card eject button all the way into the slot, and make sure the button does not
project from the panel.
2. Insert the CF card into the slot following the direction shown in Figure2-24, and make sure it
does not project from the slot.
Figure2-24 Inserting the CF card into the slot

Installing a power supply

The procedures for installing an AC power supply and DC power supply are the same. The following
uses a PSR650-A AC power supply as an example.
1. Locate the slot to install the power supply. Use even pressure to gently push the power supply
slowly along the slide rails into the slot.
Figure2-25 Inserting the power supply into the slot
2. Fasten the captive screws on the power supply.
3. After connecting the power cord, power on the power supply.
If the power supply LED is green, the power supply operates correctly. If the LED is red, the
power supply has failed.
For more information about the power supply LEDs, see H3C SR6604[6608] Routers Hardware
Information and Specifications.
26