Fasten the captive screws on the fan tray.
3.
Power on the router and check the status LED on the front panel.
4.
On means the fan tray is operating correctly. Off means the fan tray has failed the POST. For
the LED description of the fan tray, see
Installing a CF card
To install a CF card on an MCP, remove the CF card cover first.
To install a CF card:
Push the CF card eject button all the way into the slot, and make sure the button does not
1.
project from the panel.
Insert the CF card into the slot following the direction shown in
2.
not project from the slot.
Figure 26 Inserting the CF card into the slot
Installing a power module
The procedures for installing an AC power module and DC power module are the same. The
following uses a PSR650-A AC power module as an example.
Locate the slot to install the power module. Use even pressure to gently push the power module
1.
slowly along the slide rails into the slot.
Figure 27 Inserting the power module into the slot
Fasten the captive screws on the power module.
2.
After connecting the power cord, power on the power module.
3.
If the power module LED is green, the power module operates correctly. If the LED is red, the
power module has failed.
"Appendix C
LEDs."
26
Figure
26, and make sure it does