Automatic Change Of Night Service - NEC NEAX 2000 Programming Manual

AUTOMATIC CHANGE OF NIGHT SERVICE

PROGRAMMING
START
Provide the system with Automatic
CM08
Change of Night Service.
Assign the data for terminating system in
CM30
Day Mode and Night Mode for each trunk.
CM41 Specify the timing for Automatic Change of
Night Service.
END
Refer to "AUTOMATED ATTENDANT"
NOTE:
tendant as the destination of Automatic Change of Night Service.
DESCRIPTION
AUTOMATIC CHANGE OF NIGHT SERVICE
(1) 067
(2) 0: Available
Y=02 Day Mode
•
(1) 000-255: Trunk No.
(2) 14: Termination to Attendant Console
Y=03 Night Mode
•
(1) 000-255: Trunk No.
(2) 04: Direct-In Termination
09: Automated Attendant
Y=05 Night Station Assignment
•
(1) 000-255: Trunk No.
(2) X-XXXXXXXX: Night Station No.
Y=0
•
(1) 01
(2) 01-30: 4 sec.-120 sec.
(4 sec. increments)
If no data is set, the default setting is 32-36
sec.
page 56 when using the Automated At-
– 63 –
DATA
Note
A2056-10