NEC NEAX 2000 Programming Manual page 348

MCI Programming
After AP Initialization, do the following programming.
Call Forwarding to the VMS stations, and UCD Group/Station Hunting Group set to the VMS sta-
tions are required. For these feature programming, refer to each feature in this manual.
START
CM08 Provide the VMS with MCI.
Specify MSG display on the D
Specify Message Waiting control from
VMS with MCI to all stations.
MW lamp control is only avail-
NOTE:
able to the stations in the oppo-
site PBX connected with CCIS
via MCI. Station dialing MW ac-
cess codes are not allowed over
CCIS.
Specify whether Message Waiting from
the VMS is provided for the called station
when a forwarded call is terminated to the
VMS via CCIS.
Provide Message Waiting for a station with
CM13
MW lamp.
Provide VMS service for a station port
interface with the VMS (VMS station).
Provide Momentary Open for a station
port interface with the VMS (VMS station),
as required.
A
DESCRIPTION
term
.
MESSAGE CENTER INTERFACE (MCI)
(1) 443
(2) 0: VMS with MCI
(1) 025
(2) 0 : MSG (only)
1 : MSG X (X: Number of message)
(1) 444
(2) 0 : Available
1 : Not available
(1) 376
(2) 0 : To provide
1 : Not provided
Y=03
•
(1) X-XXXXXXXX: Station No.
(2) 0: To provide
Y=10
•
(1) X-XXXXXXXX: Station No.
(2) 0: To provide
Y=22
•
(1) X-XXXXXXXX: Station No.
(2) 0: To provide
– 328 –
PROGRAMMING
MCI Programming
DATA
(VMS station)
(VMS station)
A2325-10