NEC NEAX 2000 Programming Manual page 668

A
CM20
Assign the access code for Wake Up call
set or reset.
This data assignment is not re-
NOTE:
quired when Wake Up is set by
PMS.
When providing the DAT as the internal
announcement source, assign the access
code to record, replay, and delete a mes-
sage, respectively.
CM48 Designate the type of tone source for
Wake Up call.
CM10
When an External Announcement Ma-
chine is required, assign the COT card and
DK card to required LEN.
The DK card number must be as-
NOTE:
signed to the first LEN (level 0)
and the third LEN (Level 2) of
each LT slot.
B
DESCRIPTION
INITIAL
Y=0-3 Numbering Plan Group 0-3
•
(1) X-XXXX: Access Code
(2) A024: Wake Up set from guest
A025: Wake Up cancel from guest
A027: Wake Up set from administrative
station with Single Wake Up
Time operation
A028: Wake Up set from administrative
station with Multiple Wake Up
Time operation
Y=0-3 Numbering Plan Group 0-3
•
(1) X-XXXX: Access Code
(2) A100: Record
A101: Replay
A102: Delete
Y=1
•
(1) 00: Tone Source of Wake Up Call
(2) XX 00
XX: 00: No Tone
02: External Tone Source
05: Digital Announcement Trunk
14: Hold Tone Source on MP card
15: Internal Tone Generator
(1) 000-763: LEN
(2) DB00-DB09: Interface Card No. for Ex-
E800-E831: DK Card No.
For PIM0/1: E800-E807
For PIM2/3: E808-E815
For PIM4/5: E816-E823
For PIM6/7: E824-E831
NOTE:
– 648 –
AUTOMATIC WAKE UP
DATA
NOTE
NOTE
ternal Announcement
Machine
Circuit No. 3 of E831 is used
for built-in External Equip-
ment Interface on MP card by
setting CM44.
A2636-10