Uniform Call Distribution (Ucd) - NEC NEAX 2000 Programming Manual

UNIFORM CALL DISTRIBUTION (UCD)

PROGRAMMING
START
CM08 Specify the processing for an incoming
when all UCD Stations are busy.
Specify the processing for a held call after
setting the UCD Busy Out.
Specify the transferred C.O. call from a
station or an attendant is placed into queu-
ing mode when call UCD stations are
busy.
This data is only effective when
NOTE:
CM08>212 is set to 1.
Enable the UCD Busy Out set and reset
from the secondary extension.
A
DESCRIPTION
UNIFORM CALL DISTRIBUTION (UCD)
(1) 212
(2) 0 : Busy Tone Connection
1 : Queuing
(1) 214: For the held call from Tie Line
(2) 0 : Reconnected by Switch Hook
Flash
1 : Disconnected
(1) 215: For the held call from C.O. Line
(2) 0 : Reconnected by Switch Hook
Flash
1 : Disconnected
(1) 227
(2) 0 : This call is placed into queuing mode
1 : Recall to the transferring station
when the call is transferred from
station, or Attendant Camp-On is
set when the call is transferred
from Attendant.
(1) 442
(2) 0 : Available
1 : Not available
– 546 –
DATA
NOTE
A2546-10