NEC NEAX 2000 Programming Manual page 134

Metering Pulse Programming
When a metering pulse arrives from C.O. in the event of C.O. outgoing call (Local Call, Toll Call
or International Call), do the following programming.
START
CMD000 Specify the charging method.
Assign the metering function to a trunk
CM35
route.
Assign the charging rate per metering
CMD025
pulse.
CMD026 Assign the charging method development
table number to outgoing trunk route.
CMD027 Assign the Call Charge Development data
to each dial code (0-9, A (*), B (#)) on the
basis of each Charging Method Develop-
ment Table assigned by CMD026.
END
DESCRIPTION
CALL INFORMATION SYSTEM (CIS)
(1) 176
(2) 0 : Call charge by AP00 card
1 : Call charge by Advice of Charge
(AOC) from ISDN network
Y=42
•
(1) 00-63: Trunk Route No.
(2) 0
(1) 00X000
X: 0-2: Break Point
(2) 0 -9999: Charging rate
(1) 00-63: Outgoing Trunk Route No.
(2) 000 -511: Development table No.
(1) XXX Y
XXX: 000-511: Development table No.
assigned by CMD026
Y : 0-9, A (*), B (#): Dialed digit
(2) 100008
– 114 –
PROGRAMMING
Metering Pulse Programming
DATA
A2107-10