NEC NEAX 2000 Programming Manual page 481

A
To apply this feature to incoming calls, set
CM35
the trunk route combinations for Tandem
Connection.
CM36
Specify the setting method for Call For-
CM08
warding Busy Line-Outside.
Allow or restrict the ability to set Call For-
warding-Busy Line for a station with Do
Not Disturb set.
Assign whether or not an extension can
set Split Call Forwarding-Busy Line-Out-
side by entering only a trunk access code.
Assign whether or not the system should
check the trunk restriction class of the for-
warded station during a Call Forwarding-
Busy Line-Outside.
Assign Call Forwarding-Busy Line keys to
term
the D s, as required.
Assign Split Call Forwarding-Busy Line
keys to the D
B
DESCRIPTION
term
s, as required.
SPLIT CALL FORWARDING-BUSY LINE
Y=05
•
(1) 00-63: Trunk Route No.
(2) 1 : Release Signal arrives
Y=0
•
(1) Incoming Trunk Route No. + Outgoing
Trunk Route No. assigned by CM35
Y=05
(2) 0: Allow
(1) 222
(2) 0 : This feature is set when the station
goes on hook/when receiving Ser-
vice Set Tone (ORT time out)
1 : This feature is set when receiving
Service Set Tone (ORT time out)
(1) 240
(2) 0 : Allow
1 : Restrict
(1) 386
(2) 0 : Restricted
1 : Allow
(1) 387
(2) 0 : Follow trunk restriction class
1 : No check
Y=00
•
(1) My Line No. +
(2) F0014: Call Forwarding-Busy Line Set/
For setting the same key as Call Forward-
ing-Don't Answer.
(2) F0012: Set/Cancel
(1) My Line No. +
(2) F0A82: Split Call Forwarding-Busy
– 461 –
DATA
,
+ Key No.
Cancel
,
+ Key No.
Line/-Don't Answer Set/Cancel
A2452-10